Pierce Mid-Mount Ascendant Aerial Tower, Руководство пользователя, Страница: 96 / 132

OPERATION
4-22 / Mid-Mount Ascendant Aerial Tower
© 2021 Pierce Manufacturing Inc. All Rights Reserved.
10. If your apparatus was set up on uneven terrain, the frame may have relaxed after the stabilizers were stowed.
Ensure that the aerial device is properly stowed with slight down pressure for road travel by following this
procedure.
a. Position an assistant at the OVERRIDE SWITCH located above the stabilizer remote control.
b. Instruct the assistant to pull the cover back and lift UP and HOLD it in that position while you raise the device
slightly from the boom support using the controls on the control console.
c. Push forward momentarily on the aerial lowering control to apply only enough down pressure to prevent
aerial movement during road travel.
d. Instruct the assistant to release the OVERRIDE SWITCH.
4-5.3 Pre-Driving Checks
In addition to the chassis pre-trip related safety instructions found in your apparatus chassis manual, perform the
following checks on your aerial apparatus prior to driving.
•
The device is properly in its boom support with sufficient downward pressure to ensure it will not bounce during
travel.
• All Stabilizers are completely retracted.
• All compartment doors are closed and latched.
• Wheel chocks are properly restrained in their storage brackets.
• The AERIAL MASTER Switch is in the OFF position.
• The AERIAL PTO Switch is in the OFF position.
Read and follow the Safety instructions in your Pierce Chassis operator manual corresponding with
your apparatus prior to driving.
Read and following the Riding Safely instructions found in the Safety section of this manual.