PICASO 3D Designer X, Руководство пользователя

Страница: 65 / 68

QUESTIONS AND ANSWERS
64
To save a single task or a whole printlist to the 3D printer, drag it from the Polygon X task
database to the card of the connected printer in the «Network» section.
What should I do if there is no filament flow and/or I hear clicks in the printhead?
If you hear clicks when printing the first layer, loosen the nozzle z-offset by 0.05. If this
happens when printing other model layers, check the profile settings, replace the nozzle ,
and load the filament twice.
The filament flow control system monitors the main possible problems in the filament flow.
However, not all of them can be fixed by automatic algorithms. When the filament flow
control system is frequently activated, or when the flow control is turned off, pay attention
to the following:
The print profile shall match the threaded filament. The same material produced under
the brand of different manufacturers has different characteristics; each of them requires
an individual printing profile.
Filament shall have a uniform diameter of 1.75 ± 0.1 mm along the entire length of the
spool. An uneven filament diameter is a sign of poor-quality material; this can cause
printing problems.
1.
2.