removing the previous key). Leave the key in this position for 1 to 3 seconds, then
return it to the "
CLOSE
" position and remove the key.
01_24
CORRECT PROGRAMMING CHECK PHASE
Insert the "
MASTER
" key, deactivating the transponder "
C
" (by tipping the key cap
90°), and turn the key to the "
ON
" position. Perform the engine starter operation. En-
sure that the engine does not start. Insert a programmed key and repeat the start
manoeuvre. Check that motor starts.
WARNING
SHOULD YOU START THE ENGINE WITH THE MASTER KEY (WITH TRANS-
PONDER OFF) OR IN THE EVENT OF WRONG OPERATION DURING PROGRAM-
MING, REPEAT THE PROCEDURE FROM THE BEGINNING.
01_25
Saddle opening remote control (01_25)
The vehicle is equipped with a remote control to open the saddle and for the recog-
nition of the vehicle itself.
This remote control is supplied together with the keys and it has been programmed to
control the opening device control unit at the manufacturing stage. If the remote control
is lost, a new one can be requested and programmed.
•
By pressing the buttons «
1
» or «
2
» of the remote control for about 3 seconds,
the «Bike Finder» device will allow the opening at a distance of the saddle
and the recognition of the vehicle with an optical signal by flashing the turn
indicator. While holding one of the two buttons, the system will continue to
repeat the operation described above until the button is released.
•
By instead pressing the buttons «
3
» or «
4
» of the remote control, the «Bike
Finder» device will be only activated for the recognition of the vehicle by
emitting quick optical signals through the turn indicator.
29
1 Vehicle
Содержание Vespa GTS 300 HPE 2019
