-5-
PKI-0044
The numbers shown in the figure below indicate the sequence the parts should be installed.
Remove the (-) terminal
from the battery.
Remove the (+) terminal
from the battery
Bring the relay connector into the
interior of the vehicle and connect
to the switch
’
s connector.
Take the (+) cord (white) and using the
one-touch connector, tie it together to the
vehicle
’
s (+) cord.
Connect the lamp harness to the
connector.
First ground the terminal then take the (-)
cord (black) and connect it
to the (-) terminal.
Take the (+) terminal
cord (white) and attach
it to the (+) terminal and
connect to the battery
Attach the (-) terminal to
the battery
After lamp has been installed, verify the relay
harness does not make contact with the
engine
’
s moving parts or sections that emit
extreme heat. Use the wire tie included and
secure to harnesses inside engine compartment.
【2】Relay Harness Installation Sequence
Harness
Wire tie
※ Use a pair of pliers to verify the
one-touch connector is secure.
Switch
Relay
Battery
Cord
One-touch connector
(+) cord (white)
(-) cord (Black)
Make sure to properly
secure the relay unit
using bolts or a harness.
The harness must also
be facing downward.
Double-stick tape for switches Place
in area that is easily accessible from
driver
’
s seat.
Facing down
(+)cord