PI P--763 Series, Руководство пользователя

Страница: 28 / 45

6 Startup and Operation
24 Version: 1.1.0 PZ258E P­763 Nanopositioner
NOTICE
Operating voltage too high or incorrectly connected!
Operating voltages that are too high or incorrectly connected can cause damage to the P-763.

Operate the P-763 only with controllers/drivers and original accessories from PI.

Do not exceed the operating voltage range (p. 34) for which the P-763 is specified.

Operate the P-763 only when the operating voltage is properly connected; see "Pin
Assignment" (p. 36).
NOTICE
Uncontrolled oscillation!
Oscillation can cause irreparable damage to the P-763. Oscillation is indicated by a humming
noise and can be caused by the following:

A change in the load and/or dynamics requires the servo control parameters to be
adjusted.

The P-763 is operated near to its resonant frequency.
If you notice oscillation:

In closed-loop operation, switch off the servo mode immediately.

In open-loop operation, stop the P-763 immediately.
INFORMATION
Positive direction of axis motion is specified in the product view (p. 9).
INFORMATION
Sound and vibration (e.g., footfall, knocks) can be transmitted to the P-763 and can affect its
performance with regard to position stability.

Avoid sound and vibration while the P-763 is being operated.
6.2 Operating the P­763

Follow the instructions in the manual for the electronics (p. 11) used for startup and
operation of the P-763.