4
www.phywe.com, © All rights reserved
12620-09 and 12620-10 / 2715
If a sensor is connected, the name of the Cobra4 Sensor-Unit
will be displayed in the header of the display (see Fig. 7).
The navigation keys ▲▼ can be used to select the value that
is to be displayed in a large form in the main field.
The navigation key
◄ opens the analogue display.
The navigation keys
▲▼ can be used to select the value that
is to be displayed in the analogue display.
The scaling values that are displayed must be multiplied by
the value that is indicated in the lower left-hand corner. In the
example above: value x1.
The left arrow button
◄ can be used to “zoom” the scaling of
the analogue display. In doing so, the values of the display
will be divided in half. Depending on the sensor, this can be
performed up to three times.
5.3
Measurement data recording process
A measurement can be started and stopped by pressing the
confirmation key
. The measurement data recording proc-
ess is indicated by a red, flashing dot in the upper right-hand
corner of the main field of the display. The recording sym-
bol in the lower display line turns into stop symbol . The
measurement values are saved to the memory card at the set
measurement interval (Fig. 9).
Fig. 7: Display with a connected Cobra4 Sensor-Unit in the
recording mode of the main display
Fig. 6: Display when no sensor is connected to the unit.
Fig. 8: Display without a connected Cobra4 Sensor-Unit
Fig. 9: Display without a connected Cobra4 Sensor-Unit in
the recording mode of the main display
Electricity
Voltage U / V
0.00
I −0.01 A
Header
Main field
Minor field
Footer
Acceleration
Acceleration ax / g
0.00
ay −0.01 g
az −1.00 g
Acceleration
ax
−0.01 g
x1
-2
-1
0
1
2
Acceleration
Acceleration ax / g
0.00
ay −0.01 g
az −1.00 g
