Photron FASTCAM SA7, Руководство по оборудованию

Страница: 62 / 87

Chapter. 4 Connecting a PC
48
4.1. Connecting the Gigabit Ethernet Interface to a PC
The system can have the operation of its functions performed from a PC using the Gigabit Ethernet
interface. This section explains the required setup when connecting the system to a PC.
To connect a PC to the system, connect the system to a commercially available
1000BASE-T-compatible interface board with a LAN cable. For the LAN cable, prepare a UTP or
STP Cat 5e (enhanced category 5) or higher LAN cable. (UTP: unshielded, STP: shielded)
The maximum cable length between the PC and the system is, compliant to the 1000BASE-T
specification, up to 100 m. One PC can connect to a maximum of 64 Photron Gigabit Ethernet
interface equipped cameras using a hub. When connecting multiple devices, connect through a
switching hub that can connect at 1000BASE-T. The maximum length of the cable that connects the
system (or PC) to the switching hub is also 100 m.

The system is only 1000BASE-T compatible. When using a PC compatible with only 10BASE-T or
100BASE-TX, the PC must be connected through a 10BASE-T, 100BASE-TX, and 1000BASE-T
compatible switching hub.

There are two connectors equipped for prospective additional functions. Either of the
GigabitEthernet connectors is available for use.

The system's factory default IP address is below:
IP ADDRESS > GIGABIT ETHER1 192.168.0.10
GIGABIT ETHER2 192.168.1.10
NETMASK > GIGABIT ETHER 1 255.255.255.0
GIGABIT ETHER 2 255.255.255.0
GATEWAY ADDRESS > 0.0.0.0
PORT > 2000 (Fixed, not changeable)

Photron recommends using an STP cable over long distances or in noisy locations.

For the setting method of IP address for camera system, refer to
“4.1.2. Setting the IP Address”,
page 49.

For the setting method of control PC,
refer to “Photron FASTCAM Viewer User's Manual”.