Photron Fastcam BC2 HD, Руководство по оборудованию

Страница: 21 / 83

9 FASTCAM BC2 HD Hardware Manual
LED illumination/flashing in operational states
„ During low light mode operation
The LEDs other than POWER (green) and IF LINK/TRANS (red) flash at a regular interval.
„ When calibration is run from USER SW or the remote controller
The LEDs other than POWER (green) and IF LINK/TRANS (red) flash alternately from right to left three
times and from left to right three times.
„ During the Gigabit Ethernet interface initialization
The LEDs other than POWER (green) and IF LINK/TRANS (red) flash alternately from right to left and from
left to right a number of times.
• For how to initialize the Gigabit Ethernet interface, see "4.1.5 Gigabit Ethernet Interface
Initialization", page 48.
2.2.4. Interchangeable Lens Mounts
The camera's lens mount can be changed according to the recording application.
There are five types of interchangeable lens mounts: the Nikon F mount, C mount (optional
accessory), PL mount (optional accessory), B4 mount (optional accessory), and EF mount (optional
accessory).
How to change lens mounts (Example: Nikon F mount
→
PL mount)
①
Remove the four M5 hexagonal socket bolts with the hexagonal wrench.
②
Remove the Nikon F mount portion as a whole unit.
③
Attach the PL mount unit with the hexagonal socket bolts.
④
After attaching the unit, always check to ensure it is not loose or rattles.
• When using the C mount or B4 mount, clipping may occur around the edge of the video.
Nikon F Mount
(Standard)
PL Mount