Phoenix RPC12 Series, Справочное руководство CLI

Страница: 123 / 245

124 Phoenix RPC12 Series CLI Reference Manual • September 2008
set network-parameters
Description
Sets the enclosure's Ethernet parameters using a dynamic or static method.
Input
To set both controllers’ Ethernet parameters using Dynamic Host Configuration
Protocol (DHCP):
To set a controller’s Ethernet parameters statically:
set network-parameters [dhcp]
set network-parameters [ip
address
] [netmask
netmask
]
[gateway
gateway
] [controller a|b]
Parameter Description
dhcp
Optional. Specifies to use DHCP to determine the enclosure's
IP address.
ip address
Optional. Specifies the enclosure's IP address
(
xxx.xxx.xxx.xxx
).
netmask netmask
Optional. Specifies the enclosure's IP netmask
(
xxx.xxx.xxx.xxx
).
gateway gateway
Optional. Specifies the enclosure's IP gateway
(
xxx.xxx.xxx.xxx
).
controller a|b
Optional. Specifies whether to apply the settings to controller
A (upper) or controller B (lower). If this parameter is omitted,
settings are applied to the controller being accessed.