Phoenix MicroATX Express, Руководство по установке

Страница: 7 / 72

Introduction
Static Electricity Warning!
The Phoenix MicroATX Express has been designed as rugged as possible but can still be damaged if jarred sharply
or struck. Handle the motherboard with care.
The Phoenix MicroATX Express also contains delicate electronic circuits that can be damaged or weakened by
static electricity. Before removing the Phoenix MicroATX Express from its protective packaging, it is strongly
recommended that you use a grounding wrist strap. The grounding strap will safely discharge any static electricity
build up in your body and will avoid damaging the motherboard. Do not walk across a carpet or linoleum floor with
the bare board in hand.
Warranty
This product is warranted against material and manufacturing defects for two years from the date of delivery. Buyer
agrees that if this product proves defective the manufacturer is only obligated to repair, replace or refund the
purchase price of this product at manufacturer's discretion. The warranty is void if the product has been subjected to
alteration, misuse or abuse; if any repairs have been attempted by anyone other than the manufacturer; or if failure is
caused by accident, acts of God, or other causes beyond the manufacturer's control.
Phoenix MicroATX Express - An Overview
The Phoenix MicroATX Express represents the ultimate in industrial embedded motherboard technology. No other
system board available today provides such impressive list of features:
CPU Support
•
Supports Intel Pentium 4, Intel Pentium D and Intel Celeron D processors in the LGA775 socket with a
1066, 800 and 566MHz system bus.
Supported Bus Clocks
•
1066, 800 and 566MHz.
Memory
•
Four 240-pin DDR2 SDRAM module sockets up to 4GB (non-ECC), DDR2 667, DDR2 533, or DDR2 400
MHz SDRAM DIMMs. Please, refer to chapter 3 for memory details.
On-Board I/O
•
2 Floppies up to 2.88 MB.
•
Single channel PCI 32-bit EIDE controller – UDMA 66/100 supported. One standard 40-pin header and
one mini-Header 44-pin for Solid State IDE disk or any 44-pin IDE device support shared on the single primary
channel.
•
Four independent Serial ATA2 ports with transfer rates up to 300 MB/s per port.
•
Two or optional six high speed RS-232 serial ports 16 Bytes FIFO (16550). COM2 RS-232 IrDA on a
header and COM1 optional RS-422/485.
•
One bi-directional parallel port. EPP/ECP mode compatible.
•
One PS/2 mouse and one PS/2 keyboard.
V
StockCheck.com
Downloaded from StockCheck.com