Phoenix MicroATX Express, Руководство по установке

Страница: 13 / 72

Chapter 1: Pre-Configuration
CPU Installation
The Phoenix MicroATX Express currently supports the following CPUs:
•
Intel Pentium 4, Intel Pentium D and Intel Celeron D processors in the LGA775 socket with a 1066, 800
and 566MHz system bus.
Locate the CPU socket on your Phoenix MicroATX Express system board (Socket LGA775 – Figure 1-2 ). To
install a CPU, first turn off your system and remove its cover. Locate the LGA775 socket and open it by first pulling
the level sideways away from the socket then upward to a 90-degree angle. Insert the CPU with the correct
orientation as shown below. The notched corner should point toward the end of the level. Because the CPU has a
corner pin for two of the four corners, the CPU will only fit in the orientation as shown. When you put the CPU into
the LGA775 socket, no force is required to insert the CPU, and then press the level to Locate position slightly
without any extra force.
CPU LGA775 Socket
Colden Arrow
LGA775
1. Improper installation of the CPU may cause
permanent damage to both the system board and the
CPU. -- Void of warranty
2. Always handle the CPU by the edges, never touch the
pins.
3. Always use a heat-sink and a CPU fan.
When you install a DIMM module fully into the DIMM
socket the eject tab should be locked into the DIMM
module very firmly and fit into its indention on both
sides.
5
StockCheck.com
Downloaded from StockCheck.com