onlinecomponents.com
P1 ENGRAVING UNIT
103072_00_en
PHOENIX CONTACT
7
Inserting the Engraving Spindle in the Engraving Head
•
Before inserting the engraving spindle, use the
adjustment aid to check that there is a gap of three
millimeters between the depth adjuster and engraving
spindle (see Figure 20 on page 11).
•
Insert the engraving spindle in the engraving head. The
red marking on the depth adjuster must be lined up with
the arrow on the engraving head (see Figure 16 on
page 10).
•
Secure the engraving spindle with the terminal screw
(A in Figure 5).
Figure 5
Inserting the engraving spindle
Aligning the Engraving Unit
Figure 6
Alignment using the calibration block
•
Make sure that the plotter is switched off. Place the
calibration block provided on the CMS-P1-PLOTTER.
•
Move the plotter arm with the engraving head towards
the calibration block as far as it will go.
Figure 7
Alignment
•
Now use the screw (A in Figure 7) on the engraving
head to align the engraving unit at a right angle by
turning it clockwise and counter clockwise.
A suitable Torx key wrench is provided.
Assembling the Holder for the Tube and Engraving
Spindle Cable
Figure 8
Assembling the holder over the plotter pen
station
•
First push the holder for the support pipe over the
plotter base plate and then press the holder into the
side profile.
•
Insert the support pipe in the holder.
•
Attach the clamp for the suction tube and engraving
spindle cable to the support pipe.
•
To ensure that the adjustment aid (figure on page 5) is
always to hand, it can be secured to the support pipe.
Connecting the Tube and Cable to the Engraving Head
Figure 9
Connections to the engraving head
Risk of injury
The graver in the engraving spindle is sharp.
Be careful not to injure yourself.
Observe the notes on handling the engraving
spindle on page 12.
A
A
