Apply instant glue
(CA glue, super glue).
3x12mm Screw
2
2
1
3 x 35mm Cap Screw
2
3x12mm
3mm
Cable rod
INSTALLING THE RUDDER LINKAGES
The rudder is controlled by two metal cables.
Install the rudder linkages and cables as below.
1. Use a hobby knife to remove the covering from
the openings for the rudder control cables.
2. The rudder has a block wood plate for mounting
the control horn. Two control horn in positioned
on both side rudder (left and right).
3. Install the control horn to the rudder.
4. Slide a crimp onto the cable, then pass the
cable through the threaded cable end. Pass
the cable back into the crimp and use crimping
pliers to secure the crimp to the cable. Guide
the cable into the fuselage to the position for
the rudder servo.
5. Thread the metal connector to the link ball.
6. Center the rudder servo using the radio and
install the servo arm. Attach the metal clevis to
the rudder servo arm.
7. Slide a crimp onto the cable, then pass the
cable through the threaded cable end. Pass
the cable back into the crimp and use crimping
pliers to secure the crimp to the cable.
8. Thread the metal connector to the metal clevis.
9. Attach the clevis to the rudder servo. There
should be light tension on each of the wires
when installed properly.
Note:
Remember use thread locking compound
to secure.
Aluminum ball
Aluminum ball
2
2
TUCANO 60CC
Instruction Manual
20
Cable rod
Aluminum
Plate of plywood
Nut
3mm
Apply threadlocker
(screw cement).
