Phoenix Model Tiger Moth, Инструкция по эксплуатации

Страница: 17 / 40

TIGER MOTH
Instruction Manual
16
Cut off shaded portion
Apply threadlocker
(screw cement).
3x12mm
3x12mm Screw
2
2
1
3 x 30mm Cap Screw
Nut 3mm
2
INSTALLING THE RUDDER LINKAGES
The rudder is controlled by two metal cables.
Install the rudder linkages and cables as
below.
1. Use a hobby knife to remove the covering from
the openings for the rudder control cables.
2. The rudder has a block wood plate for mounting
the control horn. Two control horn in positioned
on both side rudder (left and right).
3. Install and secure the control horn to the rudder.
4. Slide a crimp onto the cable, then pass the
cable through the threaded cable end. Pass the
cable back into the crimp and use crimping
pliers to secure the crimp to the cable. Guide
the cable into the fuselage to the position for
the rudder servo.
5. Thread the metal connector to the link ball.
6. Center the rudder servo using the radio and
install the servo arm. Attach the metal clevis to
the rudder servo arm.
7. Slide a crimp onto the cable, then pass the cable
through the threaded cable end. Pass the cable
back into the crimp and use crimping pliers to
secure the crimp to the cable.
8. Thread the metal connector to the metal clevis.
9. Attach the clevis to the rudder servo. There
should be light tension on each of the wires
when installed properly.
Note: Remember use thread locking compound
to secure.
3mm
Cable rod
3x30mm
Cable
3x12mm
Aluminum ball
Aluminum ball
2
2