12
2. When satisfied with the alignment of the engine,
use a pencil and mark the mounting hole
location onto the firewall, where the throttle
pushrod will exit.
3. Now, remove the engine. Using a 5mm drill bit,
drill holes through the firewall and the forward
bulkhead at the marks made.
4. Slide the pushrod housing through the hole in
the firewall, through the hole in the forward
bulkhead, and into the servo compartment.
5. Apply a couple of drops of thin C/A to the
pushrod housing where it exits the firewall and
where it passes through the forward bulkhead.
This will secure the housing in place.
6. Using a modeling knife, cut off the nylon pushrod
housing 26mm in front of the servo tray.
INSTALLING THE ENGINE
Locate the long piece of wire used for the throttle
pushrod. One end of the wire has been
pre-bend in to a "Z" bend at the factory. This
"Z" bend should be inserted into the throttle
arm of the engine when the engine is fitted onto
the engine mount. Fit the engine to the engine
mount using the screws provided.
37
125mm
38
125mm
INSTALLING THE MOTOR AND BATTERY
This model can fly with electric, here is our
recommended for set up the system.
- Motor: RIMFIRE .60-.80 (not included)
- Lipo cell: 6 cells / 4500 – 5500mAh (not included)
- Esc: 80-100A (not included)
Installing the electric motor
39
40
41
Screw
70mm
50mm
16mm
- OS .91 Two stroke
- OS 15cc GT
P40 KITTY HAWK
Instruction Manual
INSTALLING THE THROTTLE PUSHROD HOUSING
1. Place the engine into the engine mount and
align it properly with the front of the cowling.
The distance from the firewall to the front of the
engine thrust washer should 125mm.
If your engine is equipped with a remote needle
valve, we suggest installing it into the engine at
this time.
!
