Phoenix Model BERGFALKE, Инструкция по эксплуатации

Страница: 22 / 32

INSTRUCTION MANUAL
INSTALLING THE RECEIVER AND BATTERY
1. Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron
extension into the receiver to make plugging in the
aileron servo lead easier when you are installing
the wing. Plug the battery pack lead into the
switch.
2. Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
� Do not permanently secure the receiver and battery
� until after balancing the model.
► Attach securely.
Disconnection during flight will cause loss
of control and may result in an accident
0
0
INSTALLING THE ELECTRIC MOTOR
Tape
21
BERG FALKE
INSTALLING THE SWITCH
1. The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting
holes.
2. Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
3. Secure the switch in place using the two machine
screws provided with the radio system.
Foam Pad
� Must be purchased
separately!
4 x 20mm Cap Screw
Onmimffilmm-------------
4
4mm Washer
4mm Spring Washer
© ---------------------4
3mm Mount Nut
@
- - - - - - - - - - - - - - - 4
� Must be purchased
separately!
l!'3
Apply threadlocker (screw cement).