Phoenix Model BERGFALKE, Инструкция по эксплуатации

Страница: 14 / 32

INSTRUCTION MANUAL
HORIZONTAL STABILIZER INSTALLATION
1. Using a modeling knife, cut away the covering
from the fuselage for the stabilizer and remove it.
2. Draw a center line onto the horizontal stabilizer.
3. Check the fit of the horizontal stabilizer in its slot.
Make sure the horizontal stabilizer is square and
centered to the fuselage by taking measurements,
but don't glue anything yet.
4. With the horizontal stabilizer correctly aligned, mark
the shape of the fuselage on the top and bottom of
the tail plane using a water soluble /
non-permanent felt-tip pen.
5. Remove the stabilizer. Using the lines you just
drew as a guide, carefully remove the covering
from between them using a modeling knife.
When cutting through the covering to remove it, cut
with only enough pressure to only cut through the
covering it's self. Cutting into the balsa structure
may weaken it. This could lead to possible failure
during flight. v
©
--c-------J<::=:�
�='=' -='
r;.i Apply instant glue
mil (CA glue, super glue).
fil
Cut off shaded portion
13
BERG FALKE
6. When you are sure that everything is aligned
correctly, mix up a generous amount of 30 minute
epoxy. Apply a thin layer to the top and bottom of
the stabilizer mounting area and to the stabilizer
mounting platform sides in the fuselage. Slide
the stabilizer in place and re-align. Double check
all of your measurements one more time before
the epoxy cures. Remove any excess epoxy using
a paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
7. After the epoxy has fully cured, remove the
masking tape or T-pins used to hold the stabilizer
in place and carefully inspect the glue joints. Use
more epoxy to fill in any gaps that were not filled
previously and clean up the excess using a paper
towel and rubbing alcohol.
8. Installing the elevator using C.A glue as installing
the aileron.
CI A = A'
fl
Secure nylon hinges with instant glue, being
careful vertical fin and rudder.
©
Align the center line of vertical fin with rudder.