Phoenix Contact UM IA THERMOMARK X1.1, Руководство пользователя

Страница: 109 / 130

Maintaining the Printer and Removing Errors
103180_00_ia PHOENIX CONTACT
4-9
English
4.1.10 Cleaning the Cutter
During operation, dust particles accumulate, especially in the area of the blades. Remove
these particles regularly with a soft brush or a vacuum cleaner.
Special maintenance work is necessary when you cut directly into the label material and
not in the gap between labels. In this case, the blades accumulate adhesive residue. When
you work with backfeed in cut mode, adhesive particles also accumulate in the pressure
roller. For these reasons, the pressure roller and the blades of the cutter should be cleaned
at regular intervals (see 4.1.4 on page 4-2 for how to clean the pressure roller).
Figure 4-6 Cleaning the cutter
• Disconnect the THERMOMARK X1.1 from the mains.
• Loosen screw (1) and remove the cutter from the printer.
• You can use a Philips screwdriver (with a blade width of 7 mm) to turn the axle (3) and
clean the circular blade.
• The circular blade's angle of rotation is restricted to 120° by the screw (2).
If there is a high level of soiling, loosen the screw (2) so that it protrudes by
approximately 5 mm in order to be able to turn the cutter without restriction.
• Remove all deposits from the blades using alcohol and a soft cloth or the special
cleaning pen (THERMOMARK-CP, Order No. 5145371).
Danger of injury
The blades of the cutter are sharp.
If you have removed the screw (2), the circular blade will have to be realigned after
cleaning, as described in Section 4.1.11 on page 4-10.
2
1
3