Starting up the printer
108716_en_01
PHOENIX CONTACT
2.4
Inserting the material and printing
2.4.1
Inserting the material
Figure 2-3
Inserting material off the roll
Inserting the material roll
•
Open the cover.
•
Release the margin stop (1). To do this, turn the green adjustable ring counterclockwise
until the arrow points to the
symbol.
•
Pull the margin stop off the media hub.
•
Push the material roll onto the media hub in such a way that the material side to be print-
ed faces upwards.
•
Put the margin stop back on. Push it until both margin stops are touching the material
roll. Here, a definite resistance can be felt when pushing.
•
Clamp down the margin stop. To do this, turn the adjustable ring clockwise until the ar-
row points to the
symbol.
•
Unwind a lengthy strip of the material.
Inserting material in the
printhead
•
To lift the printhead, turn the green lever (4) counterclockwise.
•
Turn the green knurled screw (3) until the material fits between the red guides.
•
Push the material below the guide roller (2) towards the printing unit. Guide the material
through below the label sensor (5).
•
Move the guides close to the edges of the material. The material must not become
jammed.
•
To close the printhead, turn the green lever clockwise.
4
3
1
2
5
Содержание THERMOMARK ROLL 2.0
Страница 1: ...User manual Operating the THERMOMARK ROLL 2 0 thermal transfer printer...
Страница 48: ...THERMOMARK ROLL 2 0 48 52 PHOENIX CONTACT 108716_en_01...
Страница 50: ...THERMOMARK ROLL 2 0 50 52 PHOENIX CONTACT 108716_en_01...
Страница 53: ......
