Phoenix Contact THERMOMARK CARD 2.0, Руководство пользователя

Страница: 17 / 46

Starting up the printer
108770_en_01 PHOENIX CONTACT
17 / 44
2.4.3 Starting a print job
• Before switching on the printer, unlock the transportation safeguard (see “Unlocking the
transportation safeguard” on page 8 ).
• Start a print job. You can also start a test print via the display (see “Test print” on
page 23 ).
The material to be inserted appears on the display. Depending on the default setting,
the compartment is moved out automatically (see “Compartment opens in case of print
job” on page 20 ).
• Move the compartment out, if necessary. To do this, touch the button on the dis-
play.
• Insert a magazine appropriate for the print job.
2.4.4 Inserting the material
• Insert the material in the magazine. Note the orientation of the material.
• You can print UCT, UM or US material even if one or more full strips are missing from
the card. However, do not insert material with incomplete strips.
• Close the compartment using the button on the display. The printer checks the
material.
If the material is inserted correctly, printing is started. Once printed, the compartment is
moved out again.
• Remove the material.
• Insert new material until the print job is complete.
• You can repeat the last printed page via the button on the display.
NOTE: Damage to the printhead
Make sure that the material is not contaminated in any way. The material must be free of
grease, fingerprints, and dust, and it must be dry.
The square markings in the corners of
the magazine and the material must
line up.
There are two pins of different length on
the bottom of the UM material. The long
pin must be on the left-hand side.
The material has two holes which fit
over the pins in the magazine. The
elongated hole must be on the left-
hand side.
UCT... UM... US...