Phoenix Contact IB IL 24 PSDO 8-PAC, Руководство пользователя, Страница: 48 / 112

IB IL 24 PSDO 8-PAC
48 / 112
PHOENIX CONTACT 7619_en_05
5.2 Parameterization in a SafetyBridge system
Parameterization includes the following:
– Specifying the SafetyBridge address for the corresponding configurable safety module
– Parameterization of outputs
SafetyBridge address The SafetyBridge address is a unique ID for the safety module in the SafetyBridge structure.
It is assigned in the configuration software for the assigned configurable safety module.
The address of the connected satellites (here: IB IL 24 PSDO 8-PAC) is based on the island
number of the configurable safety module and the position in the hardware editor of the
SAFECONF software tool.
Set this address via the DIP switches prior to mounting the safety module (see “Setting the
DIP switches” on page 40).
Parameterization of out-
puts
The parameterization of the safe outputs determines the behavior of the module and thus
has a considerable effect on the safety integrity level that can be achieved.
To parameterize the module, the parameterization of the configurable safety module cre-
ated in the parameterization tool is automatically written to the module on every power up
or reset.
The module cannot be operated if it is not parameterized.
In this case, the FS LED flashes.
The module is ready to operate if the parameters for all outputs are valid and transmitted
without errors. Valid output data is only written in this state. In any other state, every output
is set to the safe state.
If errors are detected during parameterization, the parameterization data is not transmitted.
The invalidity of the parameterization is indicated on the module by the flashing FS LED. In
addition, errors are indicated at the configurable safety module. In this case, check and cor-
rect the settings.
For more detailed information about the SafetyBridge address, please refer to the docu-
mentation for the configurable safety module used.