Phoenix Contact IB IL 24 PSDO 8-PAC, Руководство пользователя, Страница: 43 / 112

Mounting, removal, and electrical installation
7619_en_05 PHOENIX CONTACT
43 / 112
4.1.4 Mounting and removal of the safety module
Mounting
• Disconnect the power to the station.
– Snap on base • Before snapping on the safety module, remove the inserted plugs from the safety ter-
minal and the adjacent plugs from the neighboring Inline terminal on the left. This pre-
vents the potential routing knife contacts and the keyway/featherkey connection from
being damaged.
• Hold the safety module perpendicular and snap it onto the DIN rail (7.5 mm in height).
Figure 4-2 Snapping on the safety module base
• Check that all the snap-on mechanisms are securely snapped into place.
– Insert plugs • Insert the plugs in the specified order (A, B).
Figure 4-3 Inserting the connectors
For general information on mounting and removing Inline terminals, please refer to the
IL SYS INST UM E user manual.
– Set the DIP switches prior to mounting (see Section “Setting the DIP switches” on
page 40). The DIP switches cannot be accessed when the safety module is installed
in the Inline station.
– Maintain a mounting distance of 30 mm above and 40 mm below the safety module.
Shorter distances may inhibit proper handling during installation.
Ensure that all featherkeys and keyways on adjacent terminals are securely interlocked.
1A 1B
Only use the plugs supplied with the module or plugs that are approved as replacement
items (see “Ordering data: Accessories” on page 88).
B
A