Phoenix Contact FL EPA 2, Руководство пользователя

Страница: 32 / 40

FL WLAN EPA 2
4-32
PHOENIX CONTACT 108452_en_00
• Issue the “AT&F” command and reboot.
4.3 PROFINET communication
WLAN communication with PROFINET devices requires that “Bridge Mode” is set to “Layer
2 tunnel” on the “WLAN Settings” page using web-based management.
For WLAN and Bluetooth communication with PROFINET devices, it is recommended to
enable the PROFINET optimizations. This can either be done using the EasyConfig mode
or manually using an AT command.
Other real-time protocols
Profinet optimizations are also sensible when using other protocols with real-time require-
ments. Due to the large number of protocols, a general recommendation cannot be given
here. To this end, it may be necessary to perform a test.
Bluetooth optimizations
The performance of a Bluetooth Access Point (NAP) can be improved by specifying the
number of clients (PANU).
ATS2010=n (n=1…7, number of devices)
Table 4-1 Default settings (default upon delivery)
Network Settings
IP Assignment Static
IP Address 192.168.0.254
Subnet Mask 255.255.255.0
Default Gateway 192.168.0. 254
WLAN Settings
Operating Mode Client
Channel Bands 2.4 GHz and 5 GHz
Authentication Mode Open
Channel Auto
Client Operating Mode Layer 2 tunnel
Bluetooth Settings
Operating Mode PANU (Client)
Local Name Generated from MAC address
Security Mode Disabled
System Settings
Password -
Setting a secure password for the device is strongly recommended.