Phoenix Contact FL EPA 2, Руководство пользователя

Страница: 31 / 40

Web-based management
108452_en_00 PHOENIX CONTACT
4-31
Enter or paste the commands into the text field, then click on “Send”. The result codes will
be displayed below the text field.
The supported AT commands are described in the “Help” section of the web-based man-
agement and the Reference Manual for AT commands.
4.1.10 System settings
Figure 4-13 “System Settings” web page
Device Name - Enter a descriptive name for the device.
Password - Enter a password for accessing the web-based management.
Reboot System - Reboots the system without applying changes.
Cancel All Changes - Restores all parameters in the web-based management to the cur-
rently active values.
Factory Reset - Resets the device to the factory default settings and reboots.
4.2 Restoring the factory defaults
The device can be restored to the factory default settings using any of the following meth-
ods:
• Press and hold the “MODE” button for >10 seconds and then release it.
• Execute Easy Config Mode 2.
• Click on “Factory Reset” on the “System Settings” page.
If a command cannot be processed (“Error”), it is also impossible to carry out subsequent
commands.
Setting a secure password for the device is strongly recommended.