Phoenix Contact 2986229, Руководство пользователя, Страница: 83 / 102

Configuration and startup
103503_en_03 PHOENIX CONTACT
5-9
5.4 Uploading the configuration from the
PSR-TRISAFE-S safety module
A project which is downloaded to the PSR-TRISAFE-S safety module is saved there and
can be uploaded to the PC and the configuration software again if required.
This may be required, for example, if a project has to be read from the safety module for
diagnostic purposes.
To upload the project, proceed as follows:
1. If a project is currently open in the configuration software, save it before uploading the
required project from the safety module.
2. If necessary, exit startup mode and the online mode of the configuration software.
The "Online Values" icon must not be selected prior to starting the upload and the status
bar must show the controller status "Controller: Connected".
3. Click on the "Upload" icon in the toolbar:
4. Click "Yes" in the prompt dialog box that appears to confirm the upload.
5. Transmission from the safety module to the PC starts and a progress indicator is
displayed in the SAFECONF status bar.
6. If a project with the same name as the project which has just been uploaded already
exists on the PC, a prompt will appear where you must decide whether you want to
overwrite the project which is already loaded or not.
In this prompt dialog box, click:
– "Yes" to overwrite the data of the existing project with that of the project which has
just been uploaded.
Overwriting means that the current data will be lost and it will not be possible to
recover it.
– "No" to save the uploaded project under a different name or in a different directory.
The "Save Project As" dialog box appears. Here, select a directory, enter a file
name, and click on "Save".
7. You are now asked to enter the project password.
Once you have entered the password you can edit and check the project, load it to the
safety module, and start it up there as usual.
It is possible to upload a project from the safety module to the configuration software
without the controller password. However, to edit the uploaded project you will need the
correct project password.