Phoenix Contact 2702772, Руководство пользователя

Страница: 37 / 90

Configuration and startup
3785_en_B PHOENIX CONTACT
35
Similar information is then entered under “Append Delimiters from PLC” in the same group:
Start Transmission (STX): When enabled, GW EIP/ASCII... adds an STX (start of
transmission) byte sequence which is configured as one byte or two bytes when it
transmits a serial packet. If none is selected, the feature is disabled. If one byte is
selected, the GW EIP/ASCII... adds one byte the beginning of the packet. If two bytes is
selected, the GW EIP/ASCII... appends two bytes.
– Byte 1: Specifies the character that represents the first STX byte. The GW EIP/ASCII...
appends this byte if the length is one byte or two bytes. Specify a value between 0 and
FF in hexadecimal format.
– Byte 2: Specifies the character that represents the second STX byte. The
GW EIP/ASCII... adds this byte only if the length is two bytes. Specify a value between
0 and FF in decimal format.
End Transmission (ETX): When enabled, the GW EIP/ASCII... adds an ETX (end of
transmission) byte sequence that is configured as one byte or two bytes marking the end
of the serial packet. The length indicates the number of ETX bytes; if none is selected, this
function is disabled. If one byte is selected, one ETX byte is appended to identify the end
of a serial packet. If two bytes is selected, two ETX bytes are appended to identify the end
of a serial packet.
– Byte 1: Specifies the character that represents the first ETX byte. The GW EIP/ASCII...
appends this byte if the length is one byte or two bytes. Specify a value between 0 and
FF in hexadecimal format.
– Byte 2: Specifies the character that represents the second ETX byte. The
GW EIP/ASCII... adds this byte only if the length is two bytes. Specify a value between
0 and FF in decimal format.
4.8.2 EtherNet/IP configuration
The “EtherNet/IP Configuration” page sets how the Raw/ASCII data is transmitted to an
EtherNet/IP controller.
Figure 4-16 “Socket settings/Socket 1 Configuration/EtherNet/IP configuration” page
EtherNet/IP interface configuration
PLC type: The GW EIP/ASCII... provides EtherNet/IP connectivity to the entire
ControlLogix family of PLCs as well as the SLC, PLC-5, and MicroLogix PLCs. The
ControlLogix setting supports full CIP interfaces including Class 1, Write to Tag and full