13
English
EN
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
1
In standby mode, press and hold
CLOCK
for over 3 seconds.
»
[12HR] or [24HR]
begins to blink.
2
Press
+ VOL -
repeatedly to select 12/24
hour format, and then press
CLOCK
to
confirm.
»
The hour digits are displayed and begin
to blink.
3
Press
+ VOL -
repeatedly to set hour, and
then press
CLOCK
to confirm.
»
The minute digits are displayed and
begin to blink.
4
Repeat step 3 to set minute.
a
b
c
Activate demonstration mode
You can see an overview of all features.
In standby mode with clock display (if set), press
to activate the demonstration mode.
»
A demonstration of major available features
starts.
•
To deactivate the demonstration mode,
press again.
Turn on
Press .
»
The unit switches to the last selected
source.
Switch to standby mode
In working mode, press to switch the unit to
standby mode.
»
The clock (if set) appears on the display
panel.
Tip
•
The unit switches to normal standby mode after 15
minutes inactive in working mode.
Switch to ECO standby mode:
Press and hold for more than three seconds.
»
The backlight on the display panel turns off.
»
The red Eco power indicator turns on.
Tip
•
The unit switches to Eco standby mode after 15
minutes in standby mode.
MCD785_51_V4.0.indb 13
6/21/2012 1:27:39 PM
