Philips IntelliVue Series, Инструкция по установке и обслуживанию

Страница: 270 / 522

Configuration
6-44
Software Installation & Configuration
• Type in the desired
label
prefix (e.g.
Bed, Tel, Mon
) in the
Prefix:
box using the
keyboard.
• Type in the first number (typically 1) of the
Label
sequence in the
Start with Index:
box.
• Type in the desired number of labels with the
Prefix
entered above in the
Number of
labels:
field. Typically this is the number of
Beds, Telemetry Equipment
, or M3/
M4/IntelliVue
Monitors
in the clinical
Unit
.
• For
Bed Labels
, click on the clinical
Unit
where these beds reside from the
Associated with Unit
field. This field is grayed out for
Telemetry Equipment
and
Monitor
labels.
• Click
OK
to enter these
Labels
in the
Labels
list.
Step 5. Select an icon --
SCC, Switch
or
Monitor Labels
-- in the left column of the
Equipment Setup for ...
field.
If an SCC icon is selected, follow the Setup LBN Procedure that follows:
If a
Monitor Labels
icon is selected, skip to the
Setup Monitor Procedure
.
If a Switch icon is selected, skip to the Setup Switch Procedure .
Setup LBN
Procedure
Step 1. Assign SDN monitoring Equipment (hardwired and telemetry) on SCC Logical
Branch Numbers ( LBN s) to Bed Labels as follows:
• Click on (highlight) the first
SCC
in the left column of the
Equipment Setup for
Selected SCC
field.
• Click on (highlight) the first
LBN #
in the
LBN
column to activate it for assigning a
patient monitor.
• Click
Setup
to bring up the
Map Monitor to LBN #X
window for that
LBN #
.
Select the type of patient monitor attached to that LBN # -- Hardwired or Telemetry -- by
clicking in the circle preceding it.
– If Telemetry was selected, select a Label for that telemetry monitor (e.g. Tel1 ) in
the Equipment Label box.
If Hardwired was selected, proceed to the following step.
– If this patient monitor is to be assigned a
Bed Label
, click on (highlight) the
Bed
Label
to be assigned to that patient monitor from the
Located at bed
list.
If this patient monitor is not to have a bed label, click a check in the
Setup
equipment only
box.
– Click OK to enter that monitor and Bed Label assignment in the Equipment Setup
for Selected SCC.
Step 2. Repeat Step 6 for each LBN # and SCC in the list.