Philips IntelliVue Series, Инструкция по установке и обслуживанию

Страница: 254 / 522

Configuration
6-28
Software Installation & Configuration
Buttons at the bottom of the window do the following:
OK stores the information entered. It then appears in the List of network devices in
the Network Configuration window.
Cancel
closes the
Add to network domain
window with no Device being added.
The remaining buttons to the right of the List of network centrals and hallways have the
same use as for Clinical Units.
List of network devices
lists the network devices connected to this system. This field is
accessed by
Network Statistics
to provide status information on network switches and
access points.
Columns in the List of network devices field are:
Note IP Addresses for devices must be entered in this window in order to identify their
performance in the
Network Statistics
application.
If no switches are entered, then the
Equipment Setup
page will not allow any of the Mx/
IntelliVue Patient Monitor installation options.
Adding Network
Devices
In addition to adding these network devices to the Database Server/Information Center
system, the network devices must also be configured to communicate with the system. The
following table provides what their additional configuration requirements are:
Field Description
Device Name Names given to a
12-Lead ECG Management, 24 Port
-
Switch, Application Server, Holter,
Networked Printer, SNTP Time Source, Alert Data Export Client, Wireless Access Point
(with an identifying icon) on the Network of this Server. Device Names for devices are specified
in the Add new network device to this domain window when the device is added to the
network
Host Name Host name of device being added
Device Type Type of device: 12-Lead ECG Management, 24 Port - Switch, Alert Data Export Client,
Application Server, Holter, Networked Printer, SNTP Time Source, Wireless Access Point
IP Address Internet Protocol Address of the device that identifies its location on the Network.
Printer MAC Address (Media Access Control Address) is the 12 digit HEX number that uniquely identifies the printer.
This number must be obtained from the printer’s configuration printout.
Device Type Systems Supported on Requirements
12-Lead ECG Management Database Server ECG Management system must be configured to
receive Information Center data (PMDExport folder
must be created). The Database Server must be
configured with the 12-Lead ECG Management
system’s hostname
24 Port Switch all Must be configured using the Information Center
ConfigTool