Philips Domestic Appliances and Personal Care
Published by Philips Domestic Appliances and Personal Care
Printed in the Netherlands
© Copyright reserved
Subject to modification
Mobilo Duet
Vacuum cleaner
HR 8581/A
/B
/C
PRODUCT INFORMATION
- Maximum air displacement
: 37 l/sec.
- Maximum vacuum water column
: 310 cm
- Power consumption (IEC)
: 1400 W
- Dust storage capacity
: 3 litres
- Cord length
: 6.3 metres
- Filter system
: Paper dustbag
: Motor
inlet
fi
lter
: Exhaust
air
fi
lter
- Dimensions cleaner
: 44.5 x 29.5 x 25 cm
- Weight cleaner
: 5.5 kg
- Colour cleaner /A :
Brown
/B :
Green
/C :
Blue
purple
- Noise
: 77 dB
OPTIONAL
Exhaust air fi lter
HR 6932 (8836 932 01210)
Active carbon fi lter
HR 6949 (8836 949 01010)
Active carbon fi lter replacem. set HR 6968 (items 12 + 13)
S-class fi lter
HR 6992 (8836 992 01010)
S-class fi lter replacement set
HR 6994 (items 19 + 20)
Sydney cotton dustbag
HR 6997 (8836 997 01010)
Sydney closable pap. dustbag
HR 6999 (8836 999 01010)
Sydney 3-M dustbag
HR 6999 (8836 999 90010)
Accessory kit :
HR 8000
standard
HR 8001
standard plus
HR 8002
clean and shine
HR 8003
easy reach
HR 8004
clean and polish
HR 8005
clean and brush
HR
8006
animal
4322 277 00326
00/05
SERVICE INFORMATION
- To open the appliance, fi rst
remove the 2 screws of the
control panel (item 11) then
with a big screw driver dis-
connect the 2 snap locks
of panel and lower housing
(see drawing).
- Component confi guration on exploded view may differ in case
of specifi c versions. However, the actual components are distin-
guished bij means of code numbers.
- The spare parts have been standardized as much as possible.
- Item 6, cotton dustbag, is used in those countries where paper
dustbags are not available.
- Item 21 is provided with a long cord-winder spring; both long and
short cords can be used in combination with this spring.
- Cordwinder spring has to be tensioned till maximum minus
approx. 1,5 revolution.
- Depending on the original length of the cord, the spare cord must
be shortened.
- To (dis)assemble the appliance use TORX screw driver no T15
= 4822 395 10329, which is one of a set consisting of T20, T15,
TI0, T9, T8, T7 and T6 = 4822 395 50145.
- Adjusting the PCB on the motor to 220V, 60Hz.
1. Make sure that the potentiometer (item 36) is set at min.
position.
2. Adjust the potentiometer on the PCB item 45, on the motor to
220V/60Hz to allow the motor to run smoothly.
Please note: the standard setting of the spare PCB is
230V/50Hz.
There are open-circuit voltages on all wires.
This product meets the requirements regard-
ing interference suppression on radio and TV.
After the product has been repaired, it should
function properly and has to meet the safety
requirements as offi cially laid down at this
moment.
Service Manual 4322 277 00247 is herewith cancelled.
