3-1 3-1
DISMANTLING INSTRUCTIONS
Dismantling of the Lens Cassette
1) Uncatch 4 catches along the edge of the Cassette door
(pos 5) as shown in figure 1 and 2 to remove the Lens
cassette (pos 2).
Figure 2: Left Cassette door
Figure 1
1) Loosen the 4 screws, slide Cover top (pos 30) towards the
rear and remove it upwards.
2) Loosen 3 screws slide the Panel right (pos 26) towards the
rear and remove it outwards. Do likewise for the Panel left
(pos 27).
3) Push the gear slowly towards the front as shown in figure
Dismantling the 3CDC Module
3 until the CDC tray starts to move out of the Front Cabinet
(pos 8). The CDC tray is now disengage and can be pulled
out completely.
4) Remove the Cover Tray (pos 29) as shown in figure 4.
5) Loosen 4 screws A to remove the CDC Module (pos 28) as
shown in figure 3.
A
A
A
Turn the Gear towards the Front
till the CDC Tray starts to open
Figure 3
Figure 4
C1
Press Inwards
Pull Rear
Panel out
1
2
Figure 5
Dismantling of the Panel Rear
1) Loosen 6 screws C on the Panel rear (pos 24).
2) Press the 2 catches C1 inwards and dismantle the Panel
rear by pulling it towards the rear.
Содержание FWC170
