Philips FTP2.4E, Руководство по обслуживанию

Страница: 2 / 40

Technical Specifications, Connections, and Chassis Overview EN 2 FTP2.4E AB 1.
1. Technical Specifications, Connections, and Chassis Overview
Introduction:
• This manual is a supplement to the FTP2.4E_AAmanual
(3122 785 15460), and therefore only gives the additional
IBO Zapper information.
• Figures can deviate due to the different set executions.
1.1 Connections
Note: The following connector colour abbreviations are used
(acc. to DIN/IEC 757): Bk= Black, Bu= Blue, Gn= Green, Gy=
Grey, Rd= Red, Wh= White, and Ye= Yellow.
1.1.1 Rear Connections
Figure 1-1 Rear connections
CI Common Interface: PCMCIA
68p - See diagram K7
jk
Service Connector (UART)
1 - UART_TX Transmit
k
2 - Ground Gnd
H
3 - UART_RX Receive
j
DIGITAL AUDIO Cinch: S/PDIF - Out
Bk - Coaxial 0.2 - 0.6 V
PP
/ 75 ohm
kq
1.2 Chassis Overview
Figure 1-2 PWB location (photo from 50” SDI model)
2. Safety Instructions, Warnings, and Notes
See Service Manual FTP2.4E_AA (3122 785 15460).
3. Directions for Use
You can download this information from the following websites:
http://www.philips.com/support
http://www.p4c.philips.com
F_15750_007.eps
051005
AERIAL IN EXT2 EXT1
R
L R
L
EXT3 SUBW
OUT
CENTRE
IN DVI
SERVICE
AUDIO
OUT
AUDIO
IN
MAINS
(LCD SETS)
MAINS
(PLASMA SETS)
SERVICE SPDIF CI
D SIDE I/O PANEL
C PDP AUDIO PANEL
A
PDP SUPPLY PANEL
(ONLY FOR FHP SETS)
H SCART 3 PANEL
J
LED PANEL
E
CONTROL PANEL
AL AL
AMBI LIGHT PANEL AMBI LIGHT PANEL
B
SMALL SIGNAL BOARD
K
IBO ZAPPER MODULE
KS
IBO ZAPPER SUPPLY
(42” SETS ONLY)
F_15740_019.eps
101005