Mechanical Instructions
4.
4.2.7
Main Power Supply
Figure 4-8 Wall mounting bracket
1.
Remove the screws (1) at both top and bottom of the
mounting bracket.
2.
Remove the bracket before accessing the Main Power
Supply panel.
Figure 4-9 Main Power Supply
1.
Disconnect the cables from the panel.
2.
Remove the fixing screws (1) at each side of the panel.
4.2.8
LCD Panel
Figure 4-10 LCD panel
Make sure that the power is switched “off” and that all
necessary cables are disconnected.
To replace the LCD panel (including the backlight), remove all
the panels first (including the two mounting brackets), as
mentioned above.
1.
Remove the fixing screws (1) at the border of the panel with
a no. 10 Torx screwdriver.
2.
Remove the fixing screws (2) at the panel with a no. 20
Torx screwdriver.
3.
Lift the LCD panel out of the frame.
4.3
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
When as you have removed the plastic back cover, you
must
replace the speaker-box sealing foam (12nc: 3104
303 10791). This is to ensure that the loudspeakers are
airtight. Do not stretch the foam during mounting. Pay
special attention to the corners, to make sure that the foam
is not stretched and that it is pushed in the corners.
•
While re-assembling, make sure that all cables are placed
and connected in their original position
1
CL 36532064_055.eps
161003
1
CL 36532064_056.eps
201003
2
1
CL 36532064_057.eps
201003
1
FTL13U_AA_AB_312278513481.book Page 19 Thursday, December 30, 2004 1:50 PM