Philips DVP3586K, Руководство пользователя, Страница: 16 / 23

16
• [Off] - Disable digital output.
• [PCM Only] - Downmix to two-channel
audio format.
• [LPCM Output] - Select the LPCM (Linear
Pulse Code Modulation) output sampling rate.
•
[48kHZ] - For discs recorded at sampling
rate of 48 kHz.
• [96kHZ] - For discs recorded at sampling
rate of 96 kHz.
Note
•
[LPCM Output] setting is only available if the [Digital
Output] is set to [PCM Only] .
The higher the sampling rate, the better the sound
•
quality.
[HDMI Audio]
Select the HDMI audio setting when you connect
this product and the TV with an HDMI cable.
•
[On] - Allow audio output through the TV and
the speaker system. If the audio format on the
disc is not supported, it will be downmixed to
two-channel sound (linear-PCM).
• [Off] - Disable the audio output from HDMI
devices connected to this player.
[Audio Sync]
Set the delay time for audio output when you play
a video disc.
1. Press OK .
2. Press to set the delay time.
3. Press OK to confirm and exit.
[Volume]
Set the default volume level when you play a disc.
1. Press OK .
2. Press to set the volume.
3. Press OK to confirm and exit.
[Sound Mode]
Select a preset sound effect to enhance the audio
output.
•
[3D] - Select a virtual surround sound effect
that is produced from the left and right audio
channels.
• [Movie Mode] - Select a sound effect for
movies.
• [Music Mode] - Select a sound effect for
music.
[Speaker Setup]
Optimize the surround output for the connected
speakers.
[DivX(R) VOD Code]
Display the DivX
®
registration code and
deregistration code.
•
[Registration] - Obtain a registration code to
register this product on website.
• [Deregistration] - Obtain a deregistration
code to cancel the registration of this product
on website.
Note
Use this product’s DivX registration code when you rent
•
or purchase video from www.divx.com/vod. The DivX
videos rented or purchased through the DivX
®
VOD
(Video On Demand) service can be played only on the
device to which it is registered.
Audio setup
1
Press SETUP .
»
[General Setup] menu is displayed.
2
Press to select [Audio Setup] , and then
press .
3
Select an option, and then press OK .
4
Select a setting, and then press OK .
To return to the previous menu, press • .
To exit the menu, press • SETUP .
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
•
[LT/RT] - For the surround sound output
through two speakers.
• [Stereo] - For the stereo output.
• [Multi Channel] - For multi-channel output.
[Digital Audio]
Select a digital setting based on the digital amplifier/
receiver that is connected through the digital jack
(coaxial/digital).
•
[Digital Output] - Select a type of digital
output.
•
[All] - Support multi-channel audio
formats.
EN