13
EN
1
Connect your Wi-Fi enabled device to
your existing home Wi-Fi network.
2
Launch the Internet browser (for example,
Apple Safari or Microsoft Internet
Explorer) on your Wi-Fi enabled device.
3
Open the configuration page of your
home Wi-Fi router.
4
Find the Wi-Fi settings tab and write down
the following information on paper:
A
Network name (SSID)
B
Wi-Fi security mode (usually WEP,
WPA or WPA2 if enabled)
C
Wi-Fi password (if Wi-Fi security is
enabled)
D
DHCP mode (enabled or disabled)
E
Static IP address settings (if DHCP
mode is disabled)
Switch DS9830W to Assisted Wi-Fi
Setup mode
•
After successful boot-up (see 'Turn
DS9830W on' on page 8
), press and hold
WI-FI SETUP
on the back of the main
speaker.
»
The
WI-FI STATUS
indicator blinks
green and yellow alternately.
»
A new Wi-Fi network of DS9830W
itself is created, with the network name
(SSID) of
Philips_Install XXXXXX
.
»
It takes about 45 seconds for successful
creation of this new Wi-Fi network.
Note
•
After you finish manual Wi-Fi setting for DS9830W, this
new Wi-Fi network disappears.
•
If you fail to enter Assisted Wi-Fi Setup mode, power
off DS9830W and power on it, then try again after
successful boot-up.
•
Make sure that there are no other Philips AirPlay-
enabled devices in Assisted Wi-Fi Setup mode at the
same time. Multiple new Wi-Fi networks created this
way may interfere with each other.
Connect your Wi-Fi enabled device to
the newly created Wi-Fi network
The new Wi-Fi network created by DS9830W
only allows access of one Wi-Fi enabled device.
To avoid interference from any other Wi-Fi
devices, you are recommended to temporarily
disable the Wi-Fi function on your other Wi-Fi
devices.
Option 1: Use your iPod touch/iPhone/iPad
1
Select
Settings
->
Wi-Fi
on your iPod
touch/iPhone/iPad.
2
Select
Philips_Install XXXXXX
from the
list of available networks.
Содержание DS9830W
Страница 2: ......
