Philips DigiTrak XT, Инструкция по эксплуатации

Страница: 25 / 48

Changing Recorder Settings
DigiTrak XT Recorder Instructions for Use 1-17
Changing Recorder Settings
You can change various recorder settings (specified in Table 1-1) and save them (along with
the date and time settings) as the default through the
Settings
tab.
To change recorder settings
1
Select the
Settings
tab.
2
Change the settings, as necessary.
3
Select
OK
and press
Enter
to save the settings.
Saving Default Settings
To save the settings as the recorder default settings
1
Change the settings, as necessary. Change the date and time settings as necessary (located
on the
Date/Time
tab).
2
Select
Save as default
(located on the
Settings
tab) and press
Enter
to save the settings.
Pacemaker Detection
Pacemaker detection for the DigiTrak XT recorder is automatically defaulted to
OFF
. You
must turn it On for each procedure in which it is used or save the setting as part of the default
settings.
Pacemaker Threshold
The DigiTrak XT recorder allows the user to adjust the threshold for pacemaker spike
detection. The purpose of this feature is to raise or lower the threshold of the recorder
detection in order to eliminate spikes from a rate-modulated pacemaker or lower the threshold
to allow for better detection of bipolar pacemakers.
N O T E Adjusting the threshold on the DigiTrak XT recorder does NOT affect any threshold settings on the
patient’s pacemaker. The adjusting of the threshold settings are confined totally to the function of the
recorder.
You do not have to adjust the pacemaker recording threshold for all recordings.
Adjusting Pacemaker Thresholds
To adjust a pacemaker threshold
1
Select the
Settings
tab.
2
Ensure that the
Pacer Detector
setting is
ON
.
3
While viewing the ECG waveform, press
Enter
to display the pacemaker threshold
indicator on the right side of the screen.
The top position of the bar indicates maximum sensitivity. The indicator defaults to one
below the maximum sensitivity.