Philips da Vinci 46PFL6605D/77 Скачать руководство пользователя страница 25

Страница: 25 / 108

Alignments

EN 25

LC9.3L LA

2010-Jul-01

Table 6-3 White D alignment values, CA-210 color analyzer

LED panel (panel codes 233/234/236)

Without a color analyzer,

you can use below default values.

This is the next best solution. The default values are average
values coming from production (statistics).
•

Select a “Color Temperature” (e.g. “Cool”, “Normal”, or
“Warm”).

•

Set the “Whitepoint Red”, “- Green” and “- Blue” default
values according to the values in the “Tint settings” table.

•

When finished press “OK” on the RC, then press “Store” (in
the SAM root menu) to store the aligned values into the
NVM.

•

Restore the initial picture settings after the alignments.

Table 6-4 Tint settings (default values)

6.4

Option Settings

6.4.1

Introduction

The microprocessor communicates with a large number of I

ICs in the set. To ensure good communication and to make
digital diagnosis possible, the microprocessor has to know
which ICs to address. The presence/absence of these specific
ICs (or functions) is made known by the option codes.

Notes:

•

After changing the option(s), save them with the STORE
command.

•

The new option setting becomes active after the TV is
switched “off” and “on” again with the mains switch (the
EAROM is then read again).

6.4.2

Dealer Options

For dealer options, in SAM select “Dealer options”.
See

Table 6-6

6.4.3

(Service) Options

Select the sub menu's to set the initialization codes (options) of
the model number via text menus.
See

Table 6-6

6.4.4

Opt. No. (Option numbers)

Select this sub menu to set all options at once (expressed in
two long strings of numbers).
An option number (or “option byte”) represents a number of
different options. When you change these numbers directly,
you can set all options very quickly. All options are controlled
via eight option numbers.
When the NVM is replaced, all options will require resetting. To
be certain that the factory settings are reproduced exactly, you
must set both option number lines. You can find the correct
option numbers on a sticker inside the TV set and in Table
“Option code overview”.

Example:

The options sticker gives the following option

numbers:
•

25604 00386 00235 56068

•

08395 05120 00000 00000

The first line (group 1) indicates hardware options 1 to 4.
Example: option no. “2” contains the “cabinet type”.
The second line (group 2) indicates software options 5 to 8.
Example: option no. “5” contains the “display code”.
Every 5-digit number represents 16 bits (so the maximum value
will be 65536 if all options are set).
When all the correct options are set, the sum of the decimal
values of each Option Byte (OB) will give the option number.
See

Table 6-5

for the options. Always refer to the sticker in the

TV-set as leading.

Diversity

Not all sets with the same Commercial Type Number (CTN)
necessarily have the same option code!

Use of Alternative BOM

An alternative BOM number usually indicates the use of an
alternative display. This results in another Display Code thus in
another Option code. Refer to chapter

3. Precautions, Notes,

and Abbreviation List

6.4.5

Option code overview

Table 6-5 Option code overview (subject to change)

Value

Cool (9330 K)

Normal (7940 K)

Warm (6060 K)

0.282

0.293

0.320