Philips Brilliance 231C5, Руководство пользователя

Страница: 37 / 41

35
11. Troubleshooting & FAQs
%' !}
Adjust the contrast and brightness on
On-Screen Display.
An "after-image", "burn-in" or "ghost image"
remains after the power has been turned off.
Uninterrupted display of still or static
images over an extended period may cause
“burn in”, also known as “after-imaging “
or “ghost imaging”, on your screen. “Burn-
in”, “after-imaging”, or “ghost imaging” is a
well-known phenomenon in LCD panel
technology. In most cases, the “burned in”
or “after-imaging” or “ghost imaging” will
disappear gradually over a period of time
after the power has been switched off.
Always activate a moving screen saver
program when you leave your monitor
unattended.
Always activate a periodic screen refresh
application if your LCD monitor will display
unchanging static content.
Failure to activate a screen saver, or a
periodic screen refresh application may
result in severe “burn-in” or “after-image”
or “ghost image” symptoms that will not
disappear and cannot be repaired. The
damage mentioned above is not covered
under your warranty.
Image appears distorted. Text is fuzzy or
blurred.
Set the PC’s display resolution to the same
mode as monitor’s recommended screen
native resolution.
} } !} } :
on the screen
The remaining dots are normal
characteristic of the liquid crystal used in
today’s technology, Please refer the pixel
policy for more detail.
The "power on" light is too strong and is
disturbing
You can adjust “power on” light using the
power LED Setup in OSD main Controls.
For further assistance, refer to the Consumer
Information Centers list and contact Philips
customer service representative.
11.2 General FAQs
Q1: When I install my monitor what should
I do if the screen shows 'Cannot
$ € '+
Ans.: Recommended resolution for this
monitor: 1920x1080@60Hz.
Unplug all cables, then connect your PC to
the monitor that you used previously.
In the Windows Start Menu, select Settings/
Control Panel. In the Control Panel
Window, select the Display icon. Inside
the Display Control Panel, select the
‘Settings’ tab. Under the setting tab, in box
labelled ‘desktop area’, move the sidebar to
1920x1080 pixels.
Open ‘Advanced Properties’ and set the
Refresh Rate to 60Hz, then click OK.
Restart your computer and repeat step
2 and 3 to verify that your PC is set at
1920x1080@60Hz.
Shut down your computer, disconnect your
old monitor and reconnect your Philips
LCD monitor.
Turn on your monitor and then turn on
your PC.
Q2: What is the recommended refresh
[ '+
Ans.: Recommended refresh rate in LCD
monitors is 60Hz, In case of any
disturbance on screen, you can set it
up to 75Hz to see if that removes the
disturbance.
‚ƒ„ ) '
[#*+ : % €
'+
Ans.: `
monitor. Follow the instructions in your
user manual to install the drivers. Your