Philips basicPalette II, Руководство по установке и настройке

Страница: 33 / 88

Button Details
25
Palette II Lighting Control Console
Installation & Setup Guide
10. Goto
• Goto will place that cue on stage in the time setup in Show Options>Cue List. Press [GOTO] [#] [ENTER] to take
the selected Cue List to the desired cue.
• When using the [NEXT] key, a desired time for the cue to execute can be set. The recorded time is the default time.
11. Group
• A Group is a defined selection of channels at a recorded level. Activate a selection of channels at a level, then type
[RECORD] [GROUP] [1] [ENTER]. With the channels released, activate the group by typing [GROUP] [1]
[FULL] to apply the selected channels at their recorded levels. To only select the channels, type [GROUP] [1]
[ENTER]. The levels can now be adjusted with the level wheel or any level adjusting key. i.e. Full, On, Up%,
Down%.
• Technically, these are stored as Looks, but you can just record and call up groups as previous generations of desks
have done.
• See "Show Options" in the PaletteOS software Help Menu for assigning Look pages to this key.
12. Halt / Back
• The [HALT/BACK] button will halt any running cues on its Cue List. A cue is running when the Green LED on
the GO button is flashing.
• If a Cue List is halted (flashing Red LED), pressing this button again will back up the Cue List.
• If the Cue List is releasing, both the [GO] and the [HALT/BACK] LEDs will be flashing.
• [SHIFT] [BACK] will go to the previous cue in recorded time. (This is very useful for encores.)
13. Load
Note: For those familiar with previous Strand Lighting Consoles, this does not work like the 500 Series of consoles
to load a cue on a playback.
• Unlike previous Strand consoles, Load will activate the recorded item’s information for editing. [LOAD] [CUE]
[1] [ENTER] will place all contents of cue 1 into either the Live editor (if in Live Mode) or the Blind editor (if in
Blind Mode). Channel information can be edited and then updated.
• If in the dialogue box, press [S4] to load the entire state of the cue (all the cumulative levels that got you to the
Look on stage at that point in the Cue List).
• Edit the cue by changing levels, adding channels or releasing channels.
• Either press [UPDT] to update the loaded cue (watch the status area at the bottom of the screen) or press
[RECORD] to record it as a new Cue or Look.
• Press [LOAD] [LOOK] then the desired Look number to load a Look for editing.