Philips AZ1826, Руководство пользователя

Страница: 5 / 13

Batteries contain chemical substances, so
they should be disposed of properly.
Using AC Mains
1 Check if the mains supply, as shown on the type
plate located on the bottom of the set ,
corresponds to your local mains supply. If it does
not, consult your dealer or service centre.
2 Connect the power cord to the AC MAINS ~ inlet
and the wall socket. The set is now ready for use.
3 To switch the set off completely, withdraw the
power cord from the wall socket.
4 Install the unit near the AC outlet and where the
AC power plug can be easily reached.
• Disconnect the power cord from the wall socket to
protect your set during heavy thunderstorms.
Children could seriously injure themselves as the
free end of the cable may still be live if only the
connector is removed from the MAINS socket at
the back of the unit.
The type plate is located on the bottom of the
set.
IMPORTANT!
For users in the U.K.: please follow the
instructions on the lower left hand-side.
Helpful hints:
– To avoid unnecessary energy consumption, always
adjust the
Source selector to OFF after using
the set.
BASIC FUNCTIONS
Switching on and off and selecting function
1 To switch on, adjust the Source selector to
CD/USB , MW or FM as desired.
• To switch between CD and USB mode, first adjust
Source selector to CD/USB position, then press
CD/USB button once or more.
2 To switch off, adjust the Source selector to OFF .
Adjusting volume and sound
1. Adjust the volume with the VOL
3
,
4
or DBB ( on
the remote control).
™
Display shows and the volume level in
number from 00-32.
DIGITAL TUNER
Tuning to radio stations
1 Push the source selector to MW or FM .
– The radio station frequency, waveband and a
preset number (if programmed) are shown.
(See
2
)
2 Press and hold
∞
or
§
( - on the
remote control) until the frequency in the display
starts running.
™
The radio automatically tunes to a station of
sufficient reception. Display shows
during automatic tuning.
3 Repeat step 2 if necessary until you find the
desired station.
• To tune to a weak station, press
∞
or
§
( - on the remote control) briefly and
repeatedly until you have found optimal reception.
To improve radio reception:
• For FM , extend, incline and turn the telescopic
aerial. Reduce its length if the signal is too strong.
• For MW , the set uses a built-in aerial. Direct this
aerial by turning the whole set.
Programming radio stations
You can store up to a total of 20 radio stations in the
memory (20 FM and 20 MW), manually or
automatically (Autostore).
Manual programming
1 Tune to your desired station (see Tuning to radio
stations ).
2 Press PROG to activate programming.
™
Display: PROG flashes.
3 Press - , + ( PRESET
+
,
–
on the remote control)
once or more to allocate a number from 1 to 20.
4 Press PROG to confirm.
5 Repeat steps 1-4 to store other stations.
Helpful hints: You can erase a preset station by
storing another frequency in its place.
Autostore
Autostore automatically starts programming radio
stations from preset 1. Any previous presets e.g.
manually programmed will be erased.
1 Select MW or FM .
2 Press and hold PROG until displays.
™
Available stations are programmed (MW or FM).
After all stations are stored, the last autostore
preset station will then automatically play.
To listen to a preset or autostore station
Press the ALBUM / PRESET - , + (on the remote
control PRESET
+
,
–
) buttons once or more until the
desired preset station is displayed.
This set complies with the radio interference
requirements of the European Union.
POWER SUPPLY/BASIC FUNCTIONS
DIGITAL TUNER