2
Remove the 2 screws that are now visible at the bottom of the parent
unit.
3
Put the antenna in upward position and remove the screw in the back
housing that is now visible.
4
Remove the back housing from the front housing by forcing a screwdriver
in between them.
5
Disconnect the battery connector cable (black-white-red cable).
6
Remove the 4 screws from the battery holder.
7
Remove the battery.
Warranty and support
If you need information or support, please visit
www.philips.com/support
or
read the international warranty leaflet.
Frequently asked questions
This chapter summarizes the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Center in your country.
HOW TO USE / CONNECTING THE UNITS
Question
Answer
Why does the power-on
light of the baby unit
not go on when I switch
on the unit?
Perhaps the baby unit is not connected to the mains. Connect the baby unit
to the mains. Then set the on/off switch of the baby unit upwards to the ON
position to establish connection with the parent unit.
Why doesn't the parent
unit charge when I plug
it in?
Perhaps the adapter is not plugged in properly. Make sure the adapter is
plugged into the wall socket properly.
The parent unit may already be fully charged. The battery status light will be
green when the battery is fully charged and the device is connected to the
mains power.
Why doesn’t the baby
unit charge when I plug
it in?
The baby unit does not have a charging function. The baby unit only works
when it is
connected to the
mains.
Why can’t I establish a
connection?
Why is the connection
lost every now and
then?
Why are there sound
interruptions?
The baby unit and the parent unit are probably close to the outer limits of
the operating range or there is interference from other 2.4 GHz wireless
devices. Try a different location, decrease the distance between the units or
switch off other 2.4 GHz wireless devices (laptops, mobile phones,
microwaves, etc) . It can take up to 10 seconds before the connection
between the units is reestablished.
If the signal is lost, then the parent unit will make a beeping sound (3 quick
beeps every 20 seconds).
23
English
Содержание Avent SCD620
