Network settings
1
Press
and use
to Select
Setup
, then press
OK
.
2
Use
to Select
Network settings
, then press
OK
.
3
Adjust the following items.
Manual network settings
1
Use
to Select
Manual network settings
, then press
OK
.
Proxy configuration
IP configuration
Wireless network setting
Network selection
Reset network settings
Net TV
Wake-on-LAN(DIAL)
Home network
Setting status
Connection test
Manual network settings
Network selection
2
Use
to Select
Network selection
, then press
OK
.
3
Use
to Select the desired setting, then press
OK
.
Wired
If you connect to an Ethernet Cable, select
Wired
to connect to the Internet.
Wireless
If you have a router with WPS function, select
Wireless
to connect to the Internet.
Wireless network setting
This menu is displayed only when you set
Wireless
in
Network selection
.
In order to use a wireless network, you must set up a connection to the
AP (e.g. Wireless Router).
2
Use
to Select
Wireless network setting
, then press
OK
.
Auto
Search for wireless networks automatically and select the SSID from the
list.
3
Use
to Select
Auto
, then press
OK
.
4
The list of wireless networks will be displayed. Use
to Select the
appropriate the SSID, then press
OK
.
Manually enter your SSID
Auto
Router 4
Router 3
Router 2
Router 1
Manual
WPS code
Easy Connect
•
If you select the SSID with
, WEP
*2
/ WPA / WPA2 Key entry
screen will appear. Enter the WEP
*2
/ WPA / WPA2 key of the
selected wireless network using
, then press
OK
.
•
If you select the SSID has a WPS, the WPS setting screen will appear.
Use
to Select a setting, then press
OK
.
Easy Connect
Select this Setting if your Router has a Wi-Fi
Protected Setup (WPS) button. Start Scanning for
wireless networks on the TV after pressing the
WPS button on your Router. If Connection Test
fails, try
Easy Connect
again.
*1
If it fails then refer
to the Router’s Manual for more details.
WPS code
Select this Setting if your Router has a WPS but
does not have a WPS button. Enter the 8-digit
WPS PIN code shown on your TV in the Router
settings menu via PC before
Connect
is selected.
Manual
If your wireless network with authentication setting
(WEP
*2
, WPA or WPA2), WEP
*2
/ WPA / WPA2 Key
entry screen will appear. Enter the WEP
*2
/ WPA /
WPA2 key of the selected wireless network using
, then press
OK
.
*1
WPS (Easy Connect) cannot be used when the security protocol is
set to WEP. Change the Access Point’s security mode from WEP to
WPA or WPA2 (recommended).
*2
WEP is not recommended to be used due to its Major security flaws.
Change the Security protocol on the Wireless Router to WPA or
WPA2 (recommended) mode.
Confirmation message will appear. Select
OK
to complete the settings.
Note(s)
•
For a wireless network with authentication setting, key icon appears to the right hand of the
SSID.
•
Signal icon shows the strength of the signal.
•
WEP
*2
/ WPA key appears as asterisks on the confirmation screen.
•
The wireless LAN supports following specifications.
–Wireless standards: IEEE 802.1 1 a/b/g/n/ac
–Frequency spectrum: 2.5GHz / 5GHz
–Security protocol: WEP
*2
/ WPA / WPA2
41
.
English
Continued on next page.
