4 Use your TV
Switching on your TV and putting it in Standby
mode
Remote Control
TV
To Turn the TV On from Standby or Off to Standby
●
Press
B
on the TV or the Remote Control.
Note(s)
●
Energy Consumption contributes to air and water pollution. When the AC Power Cord
is plugged in, your TV consumes energy with a very low standby Power Consumption.
Adjusting Volume
Remote Control
TV
To decrease or increase Volume
●
Press
VOL
J
/
K
on the TV or press
VOL + / –
on the Remote Control.
VOL
J
(–) : Volume Down
VOL
K
(+) : Volume Up
To mute or unmute sound
●
Press
V
on the Remote Control to mute the sound.
●
Press
V
again or
VOL + / –
to recover the original sound.
Switching Channels
Remote Control
TV
To select Channels by using CH
H
/
I
or CH + / –
●
Press
CH
H
(Up) /
I
（
Down) on the TV or press
CH + / –
on the
Remote Control.
To select Channels by using the NUMBER buttons
Digital TV Operation
●
For Digital channels, press a number followed by a dot “
•
” and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press
•
before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–
When selecting Cable or Analog channel 11
Press
PREV.CH
to return to the previously viewed channel.
Note(s)
●
To select the non-memorized channels, use
the NUMBER buttons
.
●
Channel not available
or
No Signal
will appear on the TV screen after the subchannel
broadcast is over.
●
Audio Only
message will appear on the TV screen, when you receive only sound signal.
19
.
English
