Mechanical Instructions
4.
4.2
Service Position
First, put the TV set in its service position. Therefore, place it
upside down on a table top (use a protection sheet or foam
bars).
4.2.1
The Foam Bars
Figure 4-3 Foam bars
The foam bars (order code 3122 785 90580) can be used for
all types and sizes of Flat TVs. By laying the plasma or LCD TV
flat on the (ESD protective) foam bars, a stable situation is
created to perform measurements and alignments. By first
placing a mirror flat on the table under the TV you can easily
see if something is happening on the screen.
4.3
Assy/Panel Removal
4.3.1
Rear Cover
Warning:
Disconnect the mains power cord before you remove
the rear cover.
1.
Remove the screws that secure the rear cover.
2.
Lift the rear cover from the cabinet cautiously. Make sure
that wires and other internal components are not damaged
during cover removal.
4.3.2
Side I/O & Keyboard Panel Removal
Figure 4-4 Side I/O & keyboard panel
1.
Disconnect cables [1] from the panel (incl. the ground
cable).
2.
Release the two fixation clamps [2] and lift the panel out of
the bracket.
4.3.3
i-Board Removal
Figure 4-5 i-Board
1.
Disconnect all cables [1] from the i-Board.
2.
Untwist the fixation lip [2].
3.
Take out the i-Board.
E_06532_01
8
.eps
170504
F_15800_005.eps
071205
1
2
2
F_15800_004.eps
201205
1
