Philips 170M4FS/00, Руководство по обслуживанию

Страница: 83 / 83

System and equipment requirements
1. An i486 (or above) personal computer or compatible.
2. Microsoft operation system Windows 95/98 is must .
3. A/D Alignment kits (3138 106 10079):
Inclusion : a. Alignment box x1 (as Fig.1)
b. Printer cable x1
c. (D-Sub) to (D-Sub) cable x1
The updated firmware of CPU => as shown
in Fig. 3
The IIC170T4.ZIP file (3138 106 10328) Including the
1.170T4.hex
2.170T498_Flash.BAT
3.
.FlashMenu .hex
5.isp_philips.exe
6.ISP98.exe
7.T498_Flash_IIC.bat
8.XT_OSD_Font.bin
170T498_Flash_IIC.BAT
4
.
Extract the eight files from IIC170T4.ZIP to C:\IIC170T4\
as Fig. 3 .
Execution files => as shown in Fig. 4
1.After double icon, you will see
This window:as Fig.4. Attention :The monitor was power off for
a while during this period.
3.The message No mismatch means complete the process.
clicking the 170T498_Flash.bat
² ²
Go to cover page
X 83
Firmware upgrade for CPU
Note: The alignment box has already build-in a batteries socket for
using as power source. Pull out the socket by
remove four screws at the rear of box. Please do not forget that
remove batteries after programming. The energy of batteries can
only drive circuits for a short period of time.
batteries (12V)
Fig. 1 Fig. 1
A/D Alignment Kits - Digital connection A/D Alignment Kits - Digital connection
170T4
Fig. 2 Fig. 2
Fig. 3 Fig. 3
Fig. 4 Fig. 4
Fig. 5 Fig. 5
~
~
PC
T
o
video
card
T
o
printer
port
(L
TP1)
DC Power
8~12 V
To
Monitor
To PC
Printer
Port
D-Sub connector
Access Factory Mode
In pc mode press menu down key together over 10 seconds.
² ² & ² ²
Monitor will enter factory mode . The Power off /on to leave factory
mode.
Factory mode indicator
<
======
Check Firmware version : example as below.
170T4 AP V2.00 031201
IIC170T4\