background image

SLx2B Aerial amplifier instruction manual

 

 

INTRODUCTION 
 

The SLxB series amplifiers are designed to improve the picture and sound quality of TV and FM 
radio signals and distribute these to multiple locations around your home. The SLx2B can also be 
used to distribute a VCR, Digital Television and Sky™/ Sky+™ signal to two televisions around 
the home. 
 
All SLxB amplifiers have an 

integrated by-pass

 designed to allow the user control digital Sky™ 

and Sky+™ receivers from any of the connected televisions using an infrared link device and a 
Sky™ or Sky+™ compatible remote control. 
 
For added safety the SLx2B has 

built-in short circuit protection

 on each individual output. 

Should a short circuit be detected, the amplifier will only shut down the output with the short 
circuit; the other outputs will continue to function as normal. 

 

The amplifiers are easy to install and fully automatic in operation, meaning that no user 
adjustment is required. The low running cost permits continuous operation. 
 
With full instructions and wall mounting template, installing the SLx2B aerial amplifier is both 
quick and easy.

 

 

INSTALLING THE SLx2B AMPLIFIER

 

 

The SLx2B amplifier can be installed in either a room location or in a loft. Choose your installation 
position according to your personal preference. Please be aware that long runs of cable can 
become subject to interference so avoid unnecessary long lengths of cable. 

 

METHOD 1 
TV SIGNAL DISTRIBUTION

 

CONNECTION DIAGRAM 

1. Connect your UHF aerial downlead to the 

IN UHF

 socket on the SLx2B. 

2. Connect your TVs to any of the SLx2B 

TV 

sockets in any combination. 

 

METHOD 2 
TV/VCR DISTRIBUTION

 

CONNECTION DIAGRAM

 

1. Connect your UHF aerial downlead (typically via an aerial wall socket) to the aerial input on 
your VCR. 
2. Connect an aerial fly-lead from the aerial output on your VCR to the 

IN UHF 

socket on the 

SLx2B. 
3. Connect your TVs to any of the SLx2B 

TV 

sockets in any combination. 

 
Once connected, you can tune each television to traditional terrestrial channels and a channel for 
VCR viewing. 
 
If you want to connect independent VCRs in each location, connect using METHOD 1 but 
connect the SLx2B 

TV 

output/s to your VCR/s, then connect your VCR/s to your television/s. 

 
METHOD 3 
TV/VCR/SATELLITE DISTRIBUTION 

CONNECTION DIAGRAM

 

Отзывы: