Philco PMD 203 B, Руководство пользователя

Страница: 9 / 37

Copyright © 2020, Fast ČR, a. s. Revision 12/2020
EN - 7
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an electrical short circuit, earthing reduces the risk of electric
shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a
earthing wire with an earthing plug. The plug must be plugged into an outlet that is properly installed and
earthed.
WARNING: Improper use of the earthing plug can result in a risk of electric shock. Consult a qualified
electrician or serviceman if the earthing instructions are not completely understood, or if doubt exists as
to whether the appliance is properly earthed. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade earthing plug, and a 3-slot receptacle that will accept the plug on the
appliance. The marked rating of the extension cord should be equal to or greater than the electrical
rating of the appliance.
INSTALLATION
1. Ventilation
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause
a failure. For proper ventilation, allow above 100mm of space between oven sides, rear and the minimum
height of free space necessary above the top surface of the oven is 200mm.
2. Steady, flat location
This oven should be set on a steady, flat surface. This oven is designed for counter top use only.
The microwave oven shall not be placed in a cabinet unless it has been tested in a cabinet.
3. Leave space behind and side
All air vents should be kept a clearance. If all vents are covered during operation, the oven may overheat
and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference may result if the oven is located close to a TV, Radio
antenna, feeder and so on. Position the oven as far from them as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or Splash when choosing a place to position it, or the insulation
might be adversely affected and breakdowns occur.
6. Power supply
• Check your local power source. This oven requires a current of approximately 6 amperes, 230V, 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified on this oven. Using a higher voltage may result in a
fire or other accident causing oven damage. Using low voltage will cause slow cooking. We are not
responsible for damage resulting from use of this oven with a voltage of ampere fuse other than those
specified.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly
qualified persons in order to avoid a hazard.