Philco PH2313IC, Инструкция по эксплуатации

Страница: 22 / 24

23
9.6 Cautions
1. The induction hob must be installed by qualified personnel or technicians.
Please never conduct the operation by yourself.
2. The hob must not be installed directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the hob
electronics
3. The induction hob shall be installed such that better heat radiation can be
ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand
heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.
9.7 Connecting the hob to the mains power supply
This hob must be connected to the main power supply only by a qualified
person or technician.
Before connecting the hob to the main power supply, check that:
1.
The domestic wiring system is suitable for the power drawn by the hob.
2.
The voltage corresponds to the value given in the rating plate
3.
The power supply cable sections can withstand the load specified on the
rating plate.
To connect the hob to the main power supply, do not use adapters, reducers, or
extension devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so
that its temperature will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring system is suitable
without alterations.
Any alterations must only be made by a qualified electrician.
The power supply should be connected in compliance with the relevant
standard, or a single-pole circuit breaker. The method of connection is shown
below.