Philco PH2313IC, Инструкция по эксплуатации

Страница: 10 / 24

11
Touch the ON/OFF control for three seconds. After
power on, the buzzer beeps once, all displays show
“–” or “– –”, indicating that the induction hob has
entered the state of standby mode.
Place a suitable pan on the cooking zone that
you wish to use.
Make sure the bottom of the pan and the
surface of the cooking zone are clean and dry.
Touching the heating zone selection
control ,and the indicator next to the key will
flash
Select a heat setting by touching the “-” or “+”
control.
• If you don’t choose a heat setting within 1
minute, the Induction hob will automatically
switch off. You will need to start again at step 1.
• You can modify the heat setting at any
time during cooking.
If the display flashes alternately with the heat setting
This means that:
• you have not placed any cookware on the correct cooking zone or,
• the cookware you’re using is not suitable for induction cooking or,
• the cookware is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable cookware on the cooking zone.
The display will automatically turn off after 2 minutes if no suitable pan is
placed on it.
3.3.2 Finish cooking
Touching the heating zone selection control
that you wish to switch off