Philadelphia Scientific®
iBOS® Lite Installation Manual
Page 9 of 12
7. Troubleshooting
Green LED does not turn on.
•
Confirm that the Controller is plugged into its
power source.
•
Confirm that the breaker is on for the
receptacle.
•
Confirm that the
first Sentinel™ is connected
to the Controller via the provided cable.
•
If only a portion of the pool does not have the
Green LED illuminated, find the first
Sentinel™ that has the Green LED turned off.
o
Check the cable between the
Sentinel™ with the Green LED on and
the one with the Green LED off.
Amber LED does not turn on.
•
Walk down the pool and stop the charger
before disconnecting the battery.
•
Reconnect the battery and observe the amber
LED on the Sentinel™. It should light when
the battery is connected.
•
If the amber LED does not turn on, recheck
the Flexi-Tap connections to ensure good
connections have been established with the
pins penetrating into the DC charger cables.
No Blue LED on in the system.
•
There are no fully charged batteries.
•
There may have been a momentary power
outage. If so, a Blue LED should appear in
one hour.
Red LED is on.
•
The communication cable is bad.
